home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Ham Radio 2000
/
Ham Radio 2000.iso
/
ham2000
/
misc
/
fltr100
/
fltr.doc
< prev
next >
Wrap
Text File
|
1994-09-29
|
2KB
|
44 lines
FLTR 1.0 Node Filter
FLTR.EXE filters incoming DX spots on a PacketCluster
link. It passes DX spots only from designated nodes and filters
out spots from all other nodes. FLTR is a small TSR that works
in conjunction with the G8BPQ packet-switch software. To use
FLTR, load it after BPQCODE and before DEDHOST.
FLTR reads the callsigns of allowed nodes from the ASCII
file FLTR.NOD. Separate callsigns with any combination of
spaces, tabs, commas, and new lines. Use upper or lower case.
Include any SSIDs in the callsigns. The maximum length of
FLTR.NOD is 1024 bytes.
FLTR displays an error message if it can't find
FLTR.NOD, if an error occurs while reading the file, or if the
file is too large. FLTR aborts installation and sets ERRORLEVEL
to 1 whenever an error occurs. You can test ERRORLEVEL in the
batch file you use to load the program.
Because DX/callsign spots attributed to another callsign
also use that callsign as the node, FLTR will remove these spots
from the link even if they come from a designated node.
Licensing FLTR
FLTR is shareware. Although it may be freely
distributed, it's not free software. If you use the program,
you're expected to pay for it.
FLTR costs $20 for each node on which it's installed.
To license one node, simply send a $20 bill to:
Brian Beezley, K6STI
507½ Taylor St.
Vista, CA 92084